Skip to main content
Skip table of contents

Volume Detaching

Shut down all Kubernetes Pods using Longhorn volumes in order to detach the volumes. The easiest way to achieve this is by deleting all workloads and recreate them later after upgrade. If this is not desirable, some workloads may be suspended.

In this section, you’ll learn how each workload can be modified to shut down its pods.

Deployment

Edit the deployment with kubectl edit deploy/<name>.

Set .spec.replicas to 0.

StatefulSet

Edit the statefulset with kubectl edit statefulset/<name>.

Set .spec.replicas to 0.

DaemonSet

There is no way to suspend this workload.

Delete the daemonset with kubectl delete ds/<name>.

Pod

Delete the pod with kubectl delete pod/<name>.

There is no way to suspend a pod not managed by a workload controller.

CronJob

Edit the cronjob with kubectl edit cronjob/<name>.

Set .spec.suspend to true.

Wait for any currently executing jobs to complete, or terminate them by deleting relevant pods.

Job

Consider allowing the single-run job to complete.

Otherwise, delete the job with kubectl delete job/<name>.

ReplicaSet

Edit the replicaset with kubectl edit replicaset/<name>.

Set .spec.replicas to 0.

ReplicationController

Edit the replicationcontroller with kubectl edit rc/<name>.

Set .spec.replicas to 0.

Wait for the volumes using by the Kubernetes to complete detaching.

Then detach all remaining volumes from Longhorn UI. These volumes were most likely created and attached outside of Kubernetes via Longhorn UI or REST API.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.